User-programmable digital filters for gyroscope, accelerometer, and temp sensor
Digital-output temperature sensor
9-Axis MotionFusion by the on-chip digital motion processor (DMP)
Auxiliary master I2C bus for reading data from external sensors
Minimal cross-axis sensitivity between the accelerometer and gyroscope axes
MEMS structure hermetically sealed and bonded at the wafer level
10,000 g shock tolerant
400kHz fast mode I2C for communicating with all registers
Model: MG995
Weight: 55 gm
Operating voltage: 4.8V~ 7.2V
Servo Plug: JR
Stall torque @4.8V: 10 kg-cm
Stall torque @6.6V: 12 kg-cm
Working Voltage: 3.5 to 24V DC (min tested working voltage 3.5V).
Max current draw: 15mA @ 5V.
Working Flow Rate: 1 to 30 Liters/Minute.
Maximum water pressure: 1.75 MPa.
Flow rate pulse characteristics: Frequency (Hz) = 7.5 * Flow rate (L/min).
QUICK OVERVIEW
On-board level shift circuit
Arduino UNO R3 and the compatible board can directly connect to this module;
Interface logic voltage: 3.3V / 5V compatible(On-board level shift circuit);
Working voltage: 4.5~5.5V (Onboard 3.3V LDO Regulator);
Working current: 240mA(MAX).
QUICK OVERVIEW:
QUICK OVERVIEW:
| Gender | Female |
| Pin Length (mm) | 12 |
| Pin Spacing (mm) | 2.54 |
QUICK OVERVIEW
Current Ratio: 5 A:5 mA
Rated Primary Current at 50/60 Hz: 5 A
Winding D.C. Resistance at 20 °C: 155 Ω
Maximum Primary Current at 50/60 Hz: 20 A
Transformer Turns Ratio: Np:Ns = 1000:1
Self-locking/Latching Self-reset
Good electrical conductivity
This is Momentary type push-button switch
Easy to use
Light Weight
Function: Momentary
Input Voltage: DC3.6V-6V
Input Current: 2A-5A
Output Voltage: DC 400KV (Please pay attention to safety when used)
Input Line Length: about 100mm (red is positive)
Output Line Length: about 160mm
Size: 0.36 inch
Emitting Color: Red
Mode: Common-Anode (CA)
Digit: 4-Digit
Category: LED 7-Segment Display
Digital I2S interface with high precision 24-bit data
High signal to noise ratio is 61 dBA
High sensitivity – 26 dBFS
Stable frequency response from 60 Hz to 15 kHz
Low power consumption: low current consumption 1.4 mA
High PSR: -75 dBFS
QUICK OVERVIEW
Model: XKT-412.
Input Voltage: 12V.
Output Voltage: 5V.
Operating Current: 1.2-2 A.
Receive Coil: 3mm, the receiver output 5V / 1A current
Normal Use Distance: 2 ~ 10mm
Operating Current: 1.2-2 A.
Width: 10 mm
Length: About 33m.
Type: Polyimide Tape.
Heat Resistance: 200℃.
Thickness Tolerance: ±10% .
One-side Self-adhesive.
QUICK OVERVIEW
Quick review :
Inner Diameter(ID): 6 mm
Outer Diameter(D): 15 mm
Material: Bakelite
Color: Black
Weight:3 gm
QUICK OVERVIEW:
QUICK OVERVIEW:
Self-locking/Latching Self-reset
Good electrical conductivity
This is Momentary type push-button switchEasy to use
Light Weight
Function: Momentary
Model No: GA12 N20
Motor Type: Center Shaft DC Geared Motor
Base Motor: 30000 RPM
Gear Ratio: 15
RPM: 2000
Rated Voltage: 6V DC
No Load Current: 0.04 mA
Rated Current: 0.08 mA
Stall Current: 0.67 A
Rated Torque: 0.35 Kgcm
Stall Torque: 2.4 Kgcm
Shaft Type: D-type Single Side
Shaft Diameter (mm): 3mm
Shaft Length (mm): 9mm
Tie-points: 170 (10×17)
Size: 48 x 35 x 10 mm(LxWxH).
Use: experimental, testing, robot
Matching jumper, diameter 0.8mm
Phosphor bronze nickel plated spring clips
Accepts a variety of wire sizes (29-20 the AWG)
Center Frequency: 433 MHz
Wavelength: ¼-wave
VSWR: < 2.0 typical at center
Peak Gain: 3.6dBi
Impedance: 50-ohms
Holds 2 x 18650 batteries.
With a cover and locking.
Comes with an ON/OFF switch.
It also includes DC Jack.
Easy install, convenient to use.
Product Type: Bend Pin Header
Pin Configuration: 3 rows of 4 pins each
Pitch: 2.54mm (standard spacing for through-hole components)
Breakable Design: Can be easily separated into individual headers if needed.
Adjustable wrist strap with alligator clip tip.
Inner conducting layer made of stainless shell filaments.
Durable Polyurethane-Coated Coil Cords.
High-Quality Strain relief.
The soft elastic band comfort.
Rinsing Resisting.
Working voltage: DC 3.3-5V.
IC Chip: LM393
Signal output indication.
The output is digital.
Single channel signal output.
With the retaining bolt hole, convenient installation.
Output low level and the signal light when there is sound.
Operating Voltage: DC12-36V
Operating Current: <=15A
Drive Power: <=500W
Speed Voltage: 0.1V-5V
Operating Temperature: -40~85 degrees Celsius
Humidity: <=90%RH
Stall Protection: Yes
On orders above ₹999
Min. order ₹250 for COD
Available on all orders
Delivered across India
Toll Free: 1800 209 0998