Quick review :
QUICK OVERVIEW:
QUICK OVERVIEW:
Operating Voltage(V): 5 ~30
Current Consumption Max: 5 mA
Detection distance(mm): 5 mm.
Type of detection: Inductive.
Cable Length: 100cm.
Response Frequency: 500Hz Max.
Protection class: IP 67.
Quick review :
QUICK OVERVIEW:
QUICK OVERVIEW:
QUICK OVERVIEW:
QUICK OVERVIEW:
Model:PCT-225(SPL-5)
Rated Voltage:600 V
Rated Current:32 A
Color: Gray+orange
Maximum Repetitive Peak Reverse Voltage: 40V
Maximum Non-Repetitive Peak Reverse Voltage: 48V
Maximum RMS Voltage: 28V
Maximum Forward Voltage Rectified Current: 3A
Peak Forward surge Current: 80A
Operating voltage: 2.4V~12V
Low power and high noise immunity CMOS technology
Low standby current
Capable of decoding 12 bits of information
QUICK OVERVIEW:
QUICK OVERVIEW:
QUICK OVERVIEW:
Overview
QUICK OVERVIEW
Supply voltage(V):+3.3 to +5.5
operating temperature range:-40°C to +85°C
Supported Raspberry Pi and Arduino
Provide battery backup for continuous timing.
Two calendar alarm.
1Hz and 32.768kHz output.
QUICK OVERVIEW:
QUICK OVERVIEW
QUICK OVERVIEW:
Slide Switch SK-09:
Specification:
Model Number:PCT-213T
Type:Quick Disconnect
Color:transparent with orange
Rated voltage:450V
Rated current:32A
Wire diameter:0.5-4mm²
Voltage resistance:4k V
Ambient temperature:-40-105℃
String length:10mm
The number of poles:3
40A OPTO 2-4S Brushless ESC.
The applicable number of battery cells:2-4S.
BEC output: 5V 3A.
Use for F450 450mm S500 ZD550 RC Helicopter Quadcopter.
Highly intelligent, adaptive ability, extremely easy to u
QUICK OVERVIEW:
QUICK OVERVIEW:
AC input: AC 85-265V
AC frequency: 50HZ/60HZ
Output voltage: DC 24V
Output Current: 4A-6A
Output Power: 100W.
Modulation: Pulse width modulation
Quick review :
,
QUICK OVERVIEW:
QUICK OVERVIEW:
QUICK OVERVIEW:
Operating Voltage: 12V DC
Two separate LEDs for On/Off indication of the Relay
Triggering input voltage 3.3V – 5V 4)
Back EMF protection
Equipped with high-current relay 10A@250VAC / 10A@30VDC
It can control both AC and DC appliances such as Solenoids, Motors, lights, fans, etc
High-quality screw terminals (Terminal Block) provided (C, NC, NO) for quick and easy connection
Freewheeling diode to protect your microcontroller
Input Signal Pin connected to Burg stick for easy accessibility
Mounting holes provided
Type: T Type Battery Clips Connector Buckle
Compatibility: 9V batteries
Cable Length: 15cm (150mm)
Cable Color: Black and Red (for polarity identification)
Connector Type: Buckle
QUICK OVERVIEW:
Input: 3V – 35V
Output: 4V – 40V adjustable
Efficiency: 95% (MAX)
Module size: 37mm x 32mm x 15mm (L x W x H)
Operating temperature: -40 ℃ – 85 ℃
Load capacity: 80W (MAX)
Logical light indication: a small light indicate CHO electrical level.
Input feature: 5PF,100K Ohm.
USB power supply; USB logic analyzer for monitoring, analyzing and debugging digital circuits
8-Channels USB logic analyzer with a 24Mhz sampling frequency
Can analyze UART, IIC, and SPI, etc automatically
Great for MCU, ARM system and FPGA development
Voltage: 0-5.5V
QUICK OVERVIEW:
The Successful start of the drill requires three 15C-20C power battery, or six 10C-15C power battery (ordinary 18650 cannot start the drill!!)
Strictly according to map wiring 0V, 4.2V, 8.4V, 12.6V, 16.8V, do not deliberately short circuit.
Quick Overview
Quick Overview: 2mm Male & Female Gold Bullet Banana Connector (Pack of 5)
Easy to use
Best for your DIY projeccts
Self-locking/Latching Self-reset
Good electrical conductivity
This is Momentary type push-button switch
QUICK OVERVIEW
On orders above ₹999
Min. order ₹250 for COD
Available on all orders
Delivered across India
Toll Free: 1800 209 0998