Buy electronic components online in India at Zbotic. From resistors, capacitors, and inductors to semiconductor ICs, relays, LEDs, switches, connectors, and breadboards — we offer the foundational building blocks for every electronics project.
Waveshare displays, TFT LCD modules, OLED screens, e-Paper displays, and touchscreen panels in sizes from 0.96 inch to 10 inch. SPI, I2C, and parallel interfaces available for Arduino, Raspberry Pi, and ESP32 projects.
Motor driver modules including L298N, L293D, TB6612, and BTS7960 for DC motors, stepper motors, and servo control. Power supply modules — buck converters, boost converters, adjustable lab power supplies from Wanptek, DC-DC converters, and voltage regulators for every project requirement.
Through-hole and SMD components, potentiometers, crystal oscillators, diodes, transistors, MOSFETs, buzzer modules, heat sinks, USB adapters, fuse holders, relays, switches, and connectors. All components sourced from quality manufacturers at unbeatable prices.
Orders dispatched within 24 hours. Free shipping above Rs.999. COD available across India.
QUICK OVERVIEW
QUICK OVERVIEW
Rated voltage: 600V
Rated current: 32A
Number of poles: 4
Wire section :0.08~4.0mm2
Number of clamps: 8
Product Name : Potentiometer
Resistance Value : 50K ohm
Adjustment Type : Top Adjustment
Type : Single Linear (Type B)
Features : Knurled Shaft
Shaft Diameter : 6mm / 0.23″
Shaft Length : 10mm / 0.4″
Thread Hole Dia : 6.2mm / 0.24″
Base Height : 9mm / 0.35″
Base Size : 11 x 9.5mm / 0.43″ x 0.37″(L*W)
Product: IRLR7843TRPBF
Drain to Source Voltage (Vdss): 30 V
Current – Continuous Drain (Id) at 25°C: 161A (Tc)
Drive Voltage (Max Rds On, Min Rds On): 4.5V | 10V
Compatibility: Raspberry Pi 4B
Dimensions: 14mm x 14mm x 4mm
Material: Aluminum
Color: White
Rated voltage: 400V
Rated current: 32A
Number of poles: 2
Wire section: 0.08mm² to 4.0mm²
Number of clamps: 4
Flash (kBytes): 8 kBytes
Pin Count: 44
Max. Operating Freq. (MHz): 16 MHz
CPU: 8-bit AVR
No of Touch Channels: 16
Number of Pins: 40
Pin Spacing(pitch): 2.54 mm
Length of the Strip: 10mm
Pin height: 6 mm
Square Posts.
Stackable – End to End and Side to side.
Can be manually broken for the length needed.
QUICK OVERVIEW:
,
Part Number: UDN2981A
Voltage – Load: 5V ~ 50V
Current – Output (Max): 500mA
Input Type: Non-Inverting
Switch Type: General Purpose
Number of Outputs: 8
Ratio – Input: Output: 1:1
Output Configuration: High Side
Output Type: Bipolar
Interface: On/Off
Operating Temperature: -20°C ~ 85°C
Mounting Type: Through Hole
Package: 18-DIP
Rated voltage: 600V
Rated current: 32A.
Number of poles: 3
Wire section: 0.08~4.0 mm2
Number of Clamps:6
Gender: Male header
Rated Current: 3A.
Lead Spacing: 2.54mm Pitch.
Plating: Gold
Product Name: Metal Button Switch
Hole diameter: 12mm
Material: Nickel plated brass
LED color: White
Shell Color: Silver
Max current: 4A
Led voltage: 12-24V
Operation type: Momentary Self-reset
Switch contact : Flat head /High head
Waterproof level:IP66
Contact type:1NO1NC
User-programmable digital filters for gyroscope, accelerometer, and temp sensor
Digital-output temperature sensor
9-Axis MotionFusion by the on-chip digital motion processor (DMP)
Auxiliary master I2C bus for reading data from external sensors
Minimal cross-axis sensitivity between the accelerometer and gyroscope axes
MEMS structure hermetically sealed and bonded at the wafer level
10,000 g shock tolerant
400kHz fast mode I2C for communicating with all registers
QUICK OVERVIEW:
Model: PCT-222T
Rated Voltage: 220V
Rated Impulse Voltage: 4KV
Material of Insulation: Modified Nylon(PA66)
Compact, Super easy, Reliable, and Reusable.
Color: Transparent
Rated Current:32A
Rated power: 7KW
Gauge:28~12AWG
Product Type: Bend Pin Header
Pin Configuration: 3 rows of 4 pins each
Pitch: 2.54mm (standard spacing for through-hole components)
Breakable Design: Can be easily separated into individual headers if needed.
28-Pins in a Dual In-Line Packaging (2×14 pins)
Capabilities: SPI, I2C, USART, PWM
2.7V – 5.5V Input Voltage Range
1µA – 1.5mA Power Consumption (3V)
10-bit Analog-to-Digital Converter (8-channels)
Interrupt Capabilities (2-channel)
32KB of Flash Memory for Programming
Type: Photoresistor (Light Dependent Resistor)
Operating Principle: Photoconductivity
Dark Resistance: Greater than 200 MΩ
Light Resistance: Less than 2.4KΩ
Sensitivity: High sensitivity to varying light levels
Diameter: 5mm
Color: White (Note: Color may vary based on availability)
Material: High resistance semiconductor
Operating Temperature: -40°C to +70°C
Self-locking/Latching Self-reset
Good electrical conductivity
This is Momentary type push-button switch
Easy to use
Light Weight
Function: Momentary
QUICK OVERVIEW:
IC Name: IRF 9540
Package/Case: DIP-3
QUICK O VERVIEW:
Cable Length: 15 cm
Gender: Male
Easy to use
Flexible neck for longer life
MOSFET Type: P-Channel
Package Type: TO-220
Voltage Rating (Vds): 55V
Current Rating (Id): 31A
Technology: HEXFET
Dynamic dv/dt Rating: Yes
Switching Speed: Fast
Avalanche Rating: Fully rated
Resonance Frequency: 4.6 kHz +/- 0.5 kHz
Resonance Impedance: 200 Ohms
Capacitance: 20nF +/- 30% at 1 kHz
Operating Temperature: -20°C to +70°C
Storage Temperature: -30°C to +80°C
Model: WAGO 221-413
Type: Connection Terminal
Wire Connection Method: Push-in clamp
Wire Compatibility: Solid, stranded, and fine-stranded wires
Wire Cross-Section: 0.14 mm² to 4 mm² (24-12 AWG)
Maximum Voltage: 300 volts
Maximum Continuous Current: 32 amps
Housing Material: Transparent
Installation Method: Tool-free
Application: Electrical connections in various installations
Self-locking/Latching Self-reset
Good electrical conductivity
This is Momentary type push-button switch
Easy to use
Light Weight
Function: Momentary
• 5-conductor terminal
• Suitable for all types of conductors
• Visual control thanks to the transparent housing
• Two test ports
Plug-n-play.
Easy to use.
Components are easily interconnected using 20-28 AWG wire.
2.54 mm hole spacing
ABS plastic material
QUICK OVERVIEW
Fuse Holder-BF-020:
QUICK OVERVIEW:
Model: PCT-214T
Rated Voltage: 220V
Rated Impulse Voltage: 4KV
Material of Insulation: Modified Nylon(PA66)
Color: Transparent
Rated Current:32A
Rated power: 7KW
Gauge:28~12AWG
Product Name: Metal Button Switch
Hole diameter: 12mm
Material: Nickel plated brass
LED color: Red
Shell Color: Silver
Max current: 4A
Led voltage: 12-24V
Operation type: Momentary Self-reset
Switch contact : Flat head /High head
Waterproof level:IP66
Contact type:1NO1NC
170 Tie-points for Arduino, Raspberry Pi
Colour May Vary
Great addition to your hobby craft tool kit
Perfect product for your safety and lab supply
ABS Plastic material
PCB material: high-quality FR-4 material
Number of PCB layers: 2 layers
PCB thickness: 1.6mm
QUICK OVERVIEW:
Supply Voltage: 12VDC
Sound Output: 85dB
Color: Black
Wire Length: 110mm
QUICK OVERVIEW:
Drop in compatible with nRF24L01
1.9V-3.6V supply
2Mbit data rate
New long range 250kbit option
Auto acknowledge
Self-locking/Latching Self-reset.
Good electrical conductivity
This is Momentary type push-button switch.
Easy to use.
Light Weight
Product Name: Metal Button Switch
Hole diameter: 12mm
Material: Nickel plated brass
LED color: Yellow
Shell Color: Silver
Max current: 4A
Led voltage: 12-24V
Operation type: Momentary Self-reset
Switch contact : Flat head /High head
Waterproof level:IP66
Contact type:1NO1NC
On orders above ₹999
Min. order ₹250 for COD
Available on all orders
Delivered across India
Toll Free: 1800 209 0998