Loading Capacity (Kg): 2.5
D hole For BO Motor: 6 mm
Weight (gm): 34
Wheel Diameter(mm): 65 mm
ColorBlack (Tyre): Yellow (Rim)
Wheel Width 27 mm
Body Material Plastic
Grip Material Rubber
Center Shaft Hole Diameter
5.4mm-(round side) and 3.5mm-(flat side)
Omron micro switch-quality original
Lifetime: 30 million
Rated voltage:125V
Rated current: 5A
Dissipation Power: IC
Supply voltage: IC
Model number: SS-5GL
PCB installed inside of aluminum alloy U disk shell, portable, safe and reliable!
Interface definition directly marked on the shell, clear, convenient and practical!
5V, 3.3V offers at the same time, allowing you to program your target board with both 5V and 3.3V
Shell characters using laser engraving, never fade off! Permanent clarity!
500MA internal resettable fuse, complete protection of your expensive computer motherboard!
SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector
SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed
5V power supply.
Serial I2C control of LCD display using PCF8574.
Backlight can be enabled or disabled via a jumper on the board.
Contrast control via a potentiometer.
Can have 8 modules on a single I2C bus (change address via solder jumpers)address, allowing.
Wide Working Voltage Range: DC 4.5V- 20V
Current Drain: <60uA
Detection Angle: <140°
Detection Distance: 3 to 7m (can be adjusted)
Blockade time: 2.5s (Default)
Work temperature: -20- 80°C
USB Type: Type-A to Type-B
Weight: 25 gm.
Length: 50 cm.
Fully compatible with the PC.
Aluminum under-Mold shield helps meet FCC requirements on KMI/RFI interference.
5V 4-Channel Relay interface board and each one needs 15-20mA Driver Current.
Equipped with high-current relay, AC250V 10A; DC30V 10A.
Standard interface that can be controlled directly by microcontroller (for Arduino, 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL logic).
Indication LED’s for Relay output status.
Product: IRLR7843TRPBF
Drain to Source Voltage (Vdss): 30 V
Current – Continuous Drain (Id) at 25°C: 161A (Tc)
Drive Voltage (Max Rds On, Min Rds On): 4.5V | 10V