Holybro PM06D Power Module (14S)
Description:
PM06D provides a regulated power supply for your Pixhawk® 5X & 6X from the battery, as well as current consumption and battery voltage measurements, all through a 6-pin cable. It has built-in power distribution, allowing you to power your ESC and FC with the same board.
The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 14S. The Power Module comes completely assembled with an XT60 connector and a capacitor. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact.
Specification:
- Input voltage: 2S- 14S
- PCB Cont. Current Rating: 70A
- PCB Burst Current Rating: 120A (<60 Sec)
- Max current sensing: 327A
- Voltage and current monitor with I2C compatible interface
- Connector Outputs: 5.2V and 3A max
- Weight: 24.5
Current Rating:
The PM06D comes with XT60 plugs with 14 AWG silicone wires rated for 30A continuous current and 60A burst current (<1 minute). If a higher current is needed, the plug type and wire size should be changed accordingly. You can refer to this chart as a reference.
PX4 Parameter Setup:
If you are using the PM06D 14S version, you must set SENS_EN_INA228 to enable it.
Pinout
Package Includes：
Drone LiDAR Sensor Guide: Obstacle Avoidance & Mapping
Drone LiDAR Sensor Guide: Obstacle Avoidance and Precision Mapping LiDAR — Light Detection and Ranging — is one...
Read More →
Drone Weight Optimization: Every Gram Counts in FPV
Table of Contents Understanding Drone Weight Optimization Key Components and Requirements Step-by-Step Setup Guide Configuration and Optimisation Practical...
Read More →
Drone Motor KV Rating Calculator and Selection Guide
Understanding the drone motor KV rating and how to calculate the right motor for your build is fundamental...
Read More →Technical Specifications
| Brand | Holybro |
|---|---|
| Model | PM06D |
| SKU | AI3012 |
| Weight | 0.056160 kg |
| Availability | In Stock |
Applications & Use Cases
The Holybro PM06D Power Module (14S) is a versatile flight controller & accessories used across a wide range of applications including autonomous drones, FPV racing quadcopters, agricultural drones, and surveying and mapping platforms.
Common use cases:
- Central brain for drone stabilization and navigation
- GPS waypoint missions for surveying
- Acro mode flying for FPV freestyle
This product is ideal for drone builders requiring precise flight control.
Technical Tip: F4 processors are good for basic builds; F7 or H7 recommended for advanced features. Ensure firmware compatibility (Betaflight, ArduPilot, iNAV).
Shipping & Delivery
- Free shipping on orders above ₹999 across India
- Dispatched within 1-3 business days
- Expected delivery: 3-7 business days depending on location
- Secure packaging to ensure safe transit of electronic components
- Genuine Holybro product sourced from authorized channels
Reviews
There are no reviews yet.