Holybro PM06D Power Module (14S)

Description:

PM06D provides a regulated power supply for your Pixhawk® 5X & 6X from the battery, as well as current consumption and battery voltage measurements, all through a 6-pin cable. It has built-in power distribution, allowing you to power your ESC and FC with the same board.

The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 14S. The Power Module comes completely assembled with an XT60 connector and a capacitor. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact.

Specification:

• Input voltage: 2S- 14S
• PCB Cont. Current Rating: 70A
• PCB Burst Current Rating: 120A (<60 Sec)
• Max current sensing: 327A
• Voltage and current monitor with I2C compatible interface
• Connector Outputs: 5.2V and 3A max
• Weight: 24.5
  

  ---

Current Rating:

The PM06D comes with XT60 plugs with 14 AWG silicone wires rated for 30A continuous current and 60A burst current (<1 minute). If a higher current is needed, the plug type and wire size should be changed accordingly. You can refer to this chart as a reference.

PX4 Parameter Setup:

If you are using the PM06D 14S version, you must set SENS_EN_INA228 to enable it.

Pinout

Package Includes：