Picking the right flight controller that suits your needs is always a daunting task… Don’t worry we zbotic.in is here to assist you to get a quality product. Buy this Pixhawk 2.4.8 32 Bit PX4 Autopilot flight controller for your drone application. what are you have to do is just check it’s a specification.
The most common question asked by our community is “what is flight controller” and the answer is here The flight controller (aka FC) is the brain of the Drone(Quadcopter). It’s a circuit board with a range of sensors that detect movement of the drone, as well as user commands so Pixhawk 2.4.8 does. Using this data, it then controls the speed of the motors to make the craft move as instructed.
It Supports 8 RC channel with 4 serial port. Various user interfaces are available for programing, reviewing logs, even some apps for smartphones & tablets. It detects and configures all its peripherals automatically
Difference between Good quality and norma; quality pixhwak
Features of Pixhawk 2.4.8:
- The advanced 32-bit ARM CortexM4 high-performance processors; can run NuttX RTOS real-time operating system.
- 14 PWM / servo output.
- Bus interface (UART, I2C, SPI, CAN).
- The integrated backup power and backup controller fails; the primary controller fails over to the backup control is safe.
- Provide automatic and manual modes.
- Provide redundant power input and failover.
- Multicolor LED lights.
- Provide a multi-tone buzzer Interface.
Difference between Pixhawk 2.4.8 & 2.4.6:
Pixhawk Pinout Connections Ports:
Pixhawk buzzer :
This buzzer is used with Pixhawk and PX4 autopilot to annunciate status tones. The buzzer includes a two-position DF14 connector on one side that plugs directly into the Pixhawk or PX4 FMU board.The Passive buzzer has a JST-SH connector on one side that plugs directly into the Pixhawk.Once connected you will be able to hear different sounds that relate to different modes.
Specification :
- Fit for Pixhawk PX4 flight controller
- Different tones in different flight modes
- DF13 Plug,cable length 18cmMicro SD card to record flight data.
Pixhawk Saftey Switch :
This is a replacement safety switch for the Pixhawk 1. The switch is used to enable/disable the outputs to motors and servos. It also features a status LED light.
LED Meaning:
- Constant blinking – the system is initialising
- Intermittent blinking – system is ready. Press the safety switch to enable output to the motors.
- Solid – safety switch has been pressed. Motors and servos are able to move once the vehicle is armed.
Package Includes :
1 x Pixhawk 2.4.8 Main Board.
1 x Pixhawk safety switch.
1 x Pixhawk Buzzer
1 x SD Card
Reviews
There are no reviews yet.